[IPP] Initial draft of IPP 3D Printing Extensions posted

[IPP] Initial draft of IPP 3D Printing Extensions posted

Manchala, Daniel Daniel.Manchala at xerox.com
Mon Jan 26 05:18:07 UTC 2015


I am not an expert in 3D printing but the following sentence seemed a little confusing:

3.2.3 Filament Feed Jam
While printing a 3D object, the filament jams and cannot be fed into the extruder.

I thought a filament jams the extruder and hence cannot be fed 'through' the extruder rather than 'into' the extruder. This is where I got information on extruder jams from:

https://www.matterhackers.com/articles/how-to-clear-and-prevent-jams

Daniel.

________________________________________
From: ipp-bounces at pwg.org [ipp-bounces at pwg.org] on behalf of Paul Tykodi [ptykodi at tykodi.com]
Sent: Saturday, January 24, 2015 5:50 AM
To: 'Michael Sweet'
Cc: ipp at pwg.org; 3d-printing at pwg.org
Subject: Re: [IPP] Initial draft of IPP 3D Printing Extensions posted

Hi Mike,

Editorial Comments as follows:

Line 307 - suggest standardize rather than standardized.

Best Regards,

/Paul
--
Paul Tykodi
Principal Consultant
TCS - Tykodi Consulting Services LLC

Tel/Fax: 603-343-1820
Mobile: 603-866-0712
E-mail: ptykodi at tykodi.com
WWW: http://www.tykodi.com

This e-mail reply and any attachments are confidential and may be
privileged.
If you are not the intended recipient, please notify Tykodi Consulting
Services LLC
immediately by replying to this message and destroying all copies of this
message
and any attachments. Thank you


-----Original Message-----
From: ipp-bounces at pwg.org [mailto:ipp-bounces at pwg.org] On Behalf Of Michael
Sweet
Sent: Friday, January 23, 2015 5:33 PM
To: <ipp at pwg.org>; 3d-printing at pwg.org
Subject: [IPP] Initial draft of IPP 3D Printing Extensions posted

All,

I have posted an initial draft of a white paper describing a potential
extension to IPP for 3D Printing to:


http://ftp.pwg.org/pub/pwg/BOFs/3d-printing/wd-apple-ipp3d-20150123.docx

http://ftp.pwg.org/pub/pwg/BOFs/3d-printing/wd-apple-ipp3d-20150123.pdf

For discussion at the 3D Printing BOF on February 4th during the F2F.

_________________________________________________________
Michael Sweet, Senior Printing System Engineer, PWG Chair

_______________________________________________
ipp mailing list
ipp at pwg.org
https://www.pwg.org/mailman/listinfo/ipp

_______________________________________________
ipp mailing list
ipp at pwg.org
https://www.pwg.org/mailman/listinfo/ipp
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.pwg.org/pipermail/ipp/attachments/20150126/fbb75a39/attachment.html>


More information about the ipp mailing list