I've posted an updated "finishings" paper which proposes to register the
following enum values to the "finishings" Job Template attribute:
fold(10),
trim(11),
bale(12)
The previous version from March 1999 had fold and trim.
Internet Printing Protocol/1.1: "finishings" attribute values extension,
September
21, 1999, Manros, Hastings, Fullman
ftp://ftp.pwg.org/pub/pwg/ipp/proposed-registrations/attribute-values/ipp-fi
nishings-attr-vals-990921-rev.pdf
I've also posted a paper which proposes to register some new media names and
sizes from the Engineering area to the set of keywords used by the "media"
Job Template attribute. The two extra papers are pictures to explain the
"Synchro-Cut" and "synchro" values.
Internet Printing Protocol/1.1: "media" attribute values extension,
September 21,
1999, Manros, Hastings, Fullman
ftp://ftp.pwg.org/pub/pwg/ipp/proposed-registrations/attribute-values/ipp-me
dia-attr-vals-990921-rev.pdf
ftp://ftp.pwg.org/pub/pwg/ipp/proposed-registrations/attribute-values/ipp-me
dia-attr-vals-990921-examples-1-2.pdf
ftp://ftp.pwg.org/pub/pwg/ipp/proposed-registrations/attribute-values/ipp-me
dia-attr-vals-990921-examples-3-4.pdf
Sorry for the late posting. Carl-Uno will be bringing copies. Perhaps all
there will be time for is to present the proposals for the new values.
We also need to work out the kinks in the registration process for such
enums and keywords. Look at the PWG Process document for the Last Call
procedures for registration.
Thanks,
Tom