All,
I did some digging into what level of prototyping was done for the original IPP Production Printing Attributes - Set 1 specification (PWG 5100.3-2001). As near as I can tell from the mailing list archives and meeting minutes, *no* prototyping was reported. In fact, the process document that was in effect at the time (I think) was:
https://ftp.pwg.org/pub/pwg/general/process/Historical/pwg-process.pdf
The original published 5100.3 used the "PWG Draft Standard" status (corresponding to the old IETF Draft Standard status), which means that it should have had some level of prototyping, however the process document said nothing about prototyping beyond the following:
It is expected that the PWG Draft Standard takes into account implementation experience gained from prototype activities done during the development of the document.
So unless we can dig up any significant amount of prototyping that was done for 5100.3-2001, I recommend we wait for an actual prototype report for the v2.0 document.
Note: As I mentioned during today's conference call, I believe we can prototype all of the required attributes in the current draft in ippserver without too much difficulty. The attributes can be reported/supported already, but are currently not implemented by ipptransform, e.g., to use cardstock media for covers and/or add blank insert sheets and separator sheets in the right places...
________________________
Michael Sweet
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.pwg.org/pipermail/ipp/attachments/20190624/7dbd60e8/attachment.html>