FIN Mail Archive: FIN> Alignment of Xerox IPP Attributes with FIN MIB

FIN> Alignment of Xerox IPP Attributes with FIN MIB

Ron Bergman (rbergma@dpc.com)
Wed, 2 Sep 1998 18:32:54 -0700 (Pacific Daylight Time)

Xerox is requesting the registration of several new IPP
attributes that fall within the scope of the Finisher MIB.
Four of these new attributes are not currently supported in
the Finisher MIB. They are:

staple-dual-top
staple-dual-bottom
staple-dual-left
staple-dual-right

Also, the Finisher MIB "FinStitchingTypeTC" contains the
enum "stitch(10)" which is not included in the Xerox set.
This appears to be a generic enum which was to have been
replaced by "other(1)". I propose that "stitch(10)" be
removed.

The revised "FinStitchingTypeTC" enum set would be:

other(1),
unknown(2),
stapleTopLeft(4),
stapleBottomLeft(5),
stapleTopRight(6),
stapleBottomRight(7),
saddleStitch(8),
edgeStitch(9),
stapleDualTop(10),
stapleDualBottom(11),
stapleDualLeft(12),
stapleDualRight(13)

Comments?

Ron Bergman
Dataproducts Corp.