CHANGES TO THE FINISHER MIB on 9/21/98 since 8/7/98.
1. Moved the MODULE-IDENTITY to { experimental 64 }
Note: all the MIB objects are still in the Printer MIB tree.
2. Added the following enums to FinStitchingTypeTC:
stapleDualTop(10),
stapleDualBottom(11),
stapleDualLeft(12),
stapleDualRight(13)
3. Added a new attribute and textual convention:
stitchingDirection(31), StitchingDirTypeTC
INTEGER: Defines the orientation of the stitching
process.
StitchingDirTypeTC ::= TEXTUAL-CONVENTION
-- This is a type 1 enumeration.
STATUS current
DESCRIPTION
"Defines the direction, relative to the top sheet in the output
subunit, that the stitching operation was performed. For a
topDown(3) process, the staple will be clinched on the bottom
of the stack. This parameter can be used to determine what
order the pages of a booklet are to be printed such that the
staple clinch will be on the inside of the resulting booklet."
SYNTAX INTEGER {
unknown(2),
topDown(3),
bottomUp(5)
}
4. Removed the following note from section 6.1:
There are no type 1 enums in the current draft.
Ron Bergman
Dataproducts Corp.