It would appear that we overlooked adding fin types to the PrtCapacityUnitTC. The only units in PrtCapacityUnitTC are
tenThousandthsOfInches(3), micrometers(4), sheets(8), feet(16),
meters(17). How, then, are we
to indicate the capacity or max capacity of a finisher device subunit such
as a stapler?
Also, it appears that, for simple finishers, it will be redundant to
describe the capacity and max capacity in both the Device and Supply
entries. (of course, more complex finishers may have multiple supplies and
supply types). In this case, is the recommendation to just let the
redundancy exist?
FinDeviceEntry ::= SEQUENCE {
finDeviceIndex Integer32,
finDeviceType FinDeviceTypeTC,
finDevicePresentOnOff PresentOnOff,
finDeviceCapacityUnit PrtCapacityUnitTC,
finDeviceMaxCapacity Integer32,
finDeviceCurrentCapacity Integer32,
finDeviceAssociatedMediaPaths OCTET STRING,
finDeviceAssociatedOutputs OCTET STRING,
finDeviceStatus PrtSubUnitStatusTC,
finDeviceDescription OCTET STRING
and also in the
FinSupplyEntry ::= SEQUENCE {
finSupplyIndex Integer32,
finSupplyDeviceIndex Integer32,
finSupplyClass PrtMarkerSuppliesClassTC,
finSupplyType PrtMarkerSuppliesTypeTC,
finSupplyDescription OCTET STRING,
finSupplyUnit PrtMarkerSuppliesSupplyUnitTC,
finSupplyMaxCapacity Integer32,
finSupplyCurrentLevel Integer32,
finSupplyColorName OCTET STRING
----------------------------------------------
Harry Lewis
IBM Printing Systems
----------------------------------------------
This archive was generated by hypermail 2b29 : Fri Nov 10 2000 - 16:39:01 EST