Hi. Could someone help with this question re: the Finishing MIB? I
forwarded the FinPunchPatterns and FinPunchHoleTypes to the JDF Finishings
WG. It was noted that "note 8" didn't make sense as a reference axis
offset. Is this a typo, and what should it be?
enum pattern Reference Edge Reference Axis Offset
Hole spacing
---------------------------+-----------------------------+------------------
--------------------+-------------------------
twoHoleMetric(10) note 6 note 8
80 mm
where
note 8: 4 holes and 2 slots are punched in a H-H-S-S-H-H pattern with a 64,
18.5, 75, 18.5, 64 mm spacing
Thanks!
Mike
_______________________
Michael D. Shepherd
XR&T Controller Architecture
MS 128-51E
Bldg 128/153G
716.422.2338
8*222.2338
| -----Original Message-----
| From: Sommer, Tilman 2677
| [ mailto:Tilman.Sommer@de.heidelberg.com
<mailto:Tilman.Sommer@de.heidelberg.com> ]
| Sent: Thursday, July 26, 2001 11:11 AM
| To: 'MShepherd@crt.xerox.com'
| Subject: Re: Miscellanous Resource Issues
|
|
| Hi Michael,
|
| Thanks for this information you've posted.
| Just one question: The "note 8" for "twoHoleMetric"
| does not makes sense - obviously a typo. Do you know
| the correct
| axis offset for this pattern?
|
| Many thanks in advance
|
| Best regards
|
| Heidelberg Postpress
|
| Tilman Sommer
|
| Heidelberg Digital Finishing GmbH
| Software Engineering Center (SWEC)
| Breitwiesen
| 73347 Mühlhausen i.T.
| Telefon +49-7335-12-2677
| Telefax +49-7335-12-2271
| Tilman.Sommer@de.heidelberg.com
|
|
This archive was generated by hypermail 2b29 : Thu Jul 26 2001 - 13:01:41 EDT