FIN Mail Archive: FIN> RE: Miscellanous Resource Issues

FIN> RE: Miscellanous Resource Issues

From: Bergman, Ron (Ron.Bergman@Hitachi-hkis.com)
Date: Thu Jul 26 2001 - 13:50:32 EDT

  • Next message: joanna88y@yahoo.com: "FIN> Profit is our Bottom Line!"

    Mike,
     
    This should be note 5. The complete text should read:
     
    enum pattern Reference Edge Reference Axis Offset
    Hole spacing
    ---------------------------+-----------------------------+------------------
    --------------------+-------------------------
    twoHoleMetric(10) note 6 note 5
    80 mm
     
    I will make sure that this is corrected during the RFC editors phase.
     
    Thanks for bring this to my attention.
     
        Ron Bergman
        Hitachi Koki Imaging Solutions
     
     
     -----Original Message-----
    From: Shepherd, Michael [mailto:MShepherd@crt.xerox.com]
    Sent: Thursday, July 26, 2001 10:02 AM
    To: 'fin@pwg.org'
    Cc: 'harryl@us.ibm.com'; 'rbergma@hitachi-hkis.com'
    Subject: FW: Miscellanous Resource Issues

    Hi. Could someone help with this question re: the Finishing MIB? I
    forwarded the FinPunchPatterns and FinPunchHoleTypes to the JDF Finishings
    WG. It was noted that "note 8" didn't make sense as a reference axis
    offset. Is this a typo, and what should it be?
     
    enum pattern Reference Edge Reference Axis Offset
    Hole spacing
    ---------------------------+-----------------------------+------------------
    --------------------+-------------------------
    twoHoleMetric(10) note 6 note 8
    80 mm
     
    where
     
    note 8: 4 holes and 2 slots are punched in a H-H-S-S-H-H pattern with a 64,
    18.5, 75, 18.5, 64 mm spacing

    Thanks!
    Mike
    _______________________
    Michael D. Shepherd
    XR&T Controller Architecture
    MS 128-51E
    Bldg 128/153G
    716.422.2338
    8*222.2338

          | -----Original Message-----
          | From: Sommer, Tilman 2677
          | [ mailto:Tilman.Sommer@de.heidelberg.com
    <mailto:Tilman.Sommer@de.heidelberg.com> ]
          | Sent: Thursday, July 26, 2001 11:11 AM
          | To: 'MShepherd@crt.xerox.com'
          | Subject: Re: Miscellanous Resource Issues
          |
          |
          | Hi Michael,
          |
          | Thanks for this information you've posted.
          | Just one question: The "note 8" for "twoHoleMetric"
          | does not makes sense - obviously a typo. Do you know
          | the correct
          | axis offset for this pattern?
          |
          | Many thanks in advance
          |
          | Best regards
          |
          | Heidelberg Postpress
          |
          | Tilman Sommer
          |
          | Heidelberg Digital Finishing GmbH
          | Software Engineering Center (SWEC)
          | Breitwiesen
          | 73347 Mühlhausen i.T.
          | Telefon +49-7335-12-2677
          | Telefax +49-7335-12-2271
          | Tilman.Sommer@de.heidelberg.com
          |
          |

    This archive was generated by hypermail 2b29 : Thu Jul 26 2001 - 13:44:23 EDT