WIMS> CIM> posted new Visio diagrams of CIM Printer classes

From: Richard_Landau@Dell.com
Date: Wed Nov 19 2008 - 16:23:59 EST

  • Next message: konstantin.vorobyev@nts.ricoh.co.jp: "WIMS> Vendor information in CIM_Printer"

    in ftp://ftp.pwg.org/pub/pwg/wims/cim/Visio-Printer_16.pdf and the
    source .vsd file.

    Minor changes to associations:
    - CIM_PrintInterlock is not mandatory, should use CIM_ConcreteComponent
    instead of CIM_PrinterComponent.
    - On the last page, the assocations between the Printer (device) and its
    components are now PrinterComponent and ConcreteComponent, to
    accommodate optional subunits.
    - The associations between Finisher and MediaPath and between Finisher
    and OutputTray have a cardinality of one required at the Finisher end;
    that is, an OutputTray or MediaPath cannot be associated with more than
    one Finisher.

    rick
    ----------------------
    Richard_Landau(at)dell(dot)com, Stds & System Mgt Architecture, CTO
    Office
    +1-512-728-9023, One Dell Way, RR5-3, MS RR5-32, Round Rock, TX 78682

    This archive was generated by hypermail 2.1.4 : Wed Nov 19 2008 - 16:24:06 EST