I would like to get your comment on the following issue:
The finDeviceTable contains two object - finDeviceAssociatedMediaPaths and
finDeviceAssociatedOutputs. Both of these object are bitmap arrays in which
the bit position corresponds to an index (prtMediaPathIndex and
prtOutputIndex respectively) into another table. However, both of these
indices can range from 1 to 65535. This means the possibility exists for
there to be 4192 bytes required if the upper end of the range is used. I
know of no requirement not to use those large values. It is quite likely
that object this size may not even fit into a single PDU.
What is your comment on this?
Thanks,
Mike Elvers
Xerox Corporation
(716) 425-6449