The diagram for the Job State transition is incorrect.
1) The transition from Pending to PendingHeld only shows the
HoldJob event. According to the definition of the PendingHeld state
"the job is not a candidate for processing for any number of reasons and
will return to the Pending state when the reasons are no longer
present". An example could be an unavailable resource.
2) The transition from Processing to ProcessingStopped says
"Service Stopped". I believe that it should be "Job or Service
Stopped". The commands Suspend<service>Job and Resume<service>Job cause
the transitions. A required resource or a critical fault will cause the
transition to ProcessingStopped. The resource becoming available or
clearing the critical fault can cause the reverse transition. The
currently described Service conditions for the transition remain valid.
Xerox Research Center Webster
Email: Peter.Zehler at Xerox.com <mailto:Peter.Zehler at Xerox.com>
Voice: (585) 265-8755
FAX: (585) 265-7441
US Mail: Peter Zehler
800 Phillips Rd.
Webster NY, 14580-9701
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
-------------- next part --------------
An HTML attachment was scrubbed...