>> Hi everyone,
>> I talked to George C. about the three possible ways we were considering for
> setting connection parameters:
>> 1. Using command-set dependant management commands. There is no way
> for the class driver to cause the SBP-2 driver to send these, so I guess
> they are out.
Too bad.
> 2. Using additional registers in the command agent register block.
> There is no way for the class driver to discover these addresses or to
> deliver requests directly to the 1394 bus driver, so again no luck.
Oh well.
> 3. Using commands in the normal command stream. This will work (as we
> knew in Monterey), so we'll have to figure out a way to ensure that the in
> and out queues are both idle when they are issued (but we really needed to
> do that for 1 & 2 as well).
Any progress on getting the Device Type to be dependent on Command_Set?
--
Greg Shue
Hewlett-Packard Company
All-in-One Division gregs at sdd.hp.com
----------------------------------------------------------------