[PMP] WIMS F2F

[PMP] WIMS F2F

William A Wagner wamwagner at comcast.net
Thu Feb 9 20:09:10 UTC 2012


Since MFD finished early, the WIMS meeting will start today at 1:15 PST
(4:15 EST).

Thanks

 

Bill Wagner

 

From: wims-bounces at pwg.org [mailto:wims-bounces at pwg.org] On Behalf Of
William A Wagner
Sent: Thursday, February 09, 2012 12:17 PM
To: wims at pwg.org; pmp at pwg.org
Subject: [WIMS] Minutes from Thursday 26 Jan

 

For the Face to Face meeting at 2PM PST (5PM EST) today:

 

Minutes from last meeting (from Danny B.):
ftp://ftp.pwg.org/pub/pwg/wims/minutes/wims_120126.pdf 

 

We will also be discussing the latest MFD Alerts document
(ftp://ftp.pwg.org/pub/pwg/pmp/wd/wd-pmpmfdalerts10-20120203-rev.pdf )

And, in relation to Randy's request for correlation to EMAN activities,
consideration of Ira's recent eman communication. (copied below)

Thanks,

Bill W.

==========

Hi Daniel,

Relevant to your questions, you might want to look at our IEEE-ISTO 
Printer Working Group candidate standards for Printers and MFDs:

"Power Management Model for Imaging Systems v1.0"
ftp://ftp.pwg.org/pub/pwg/candidates/cs-wimspower10-20110214-5106.4.pdf

"PWG Imaging System Power MIB v1.0"
ftp://ftp.pwg.org/pub/pwg/candidates/cs-wimspowermib10-20110214-5106.5.pdf

"PWG-IMAGING-SYSTEM-POWER-MIB" - ASN.1 source
ftp://ftp.pwg.org/pub/pwg/candidates/cs-wimspowermib10-20110214-5106.5.mib

The PowerLog group defines a FIFO list of state transitions
with time stamps.

The PowerTrap group defines a notification to report state
transitions.

The PowerSupport group defines objects about the capabilities
of the device (or component/subunit) in a given state.

The PowerTransition group defines objects for nominal state
transition times between any two supported power states.

The Power[Calendar/Timeout/Event] groups define objects for
configured power transitions for device or component based
on calendar (like IETF Schedule MIB), timeout, or event
triggers.

BTW - This MIB uses the standard DMTF CIM power states,
but allows vendor extension substates (e.g., fine-grained
Suspend substates).

And this MIB defines explicit light sleep (Standby) and deep
sleep (Suspend) states and their standard behaviors - note that
Bruce Nordman does not like the use of these terms, but all
Printers/MFDs that support power management have always
made this distinction in the their private MIBs and embedded
web servers.

Cheers,
- Ira (editor of the PWG power standards)


-- 
This message has been scanned for viruses and 
dangerous content by  <http://www.mailscanner.info/> MailScanner, and is 
believed to be clean. 


-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.pwg.org/pipermail/pmp/attachments/20120209/d3849ff2/attachment-0001.html>


More information about the pmp mailing list