I see I made a boo-boo when converting to use the IEEE-ISTO Template (which
I stole from the PWG Media standard).
I didn't change the IEEE-ISTO number in the upper right hand corner of the
It currently says 5101.1 (which is the PWG Media standard!).
Its done as an MS-WORD Header, so if you don't look at the Headers and
Footers (which you don't see in Normal Mode), you can forget to change the
header to the correct number, which is the error that I made.
It should have said 5100.5 (which is what is said everywhere else in the
We should also put the word Draft and D0.4 in the header as well.
So it should have said something like the following in the upper right
Draft 0.4 for IEEE-ISTO 5100.5-2002
Sorry about that,
From: Zehler, Peter [mailto:PZehler@crt.xerox.com]
Sent: Thursday, October 17, 2002 06:02
To: PWG Semantic Model WG (E-mail); IPP Discussion List (E-mail)
Subject: SM> Semantic Model review of Document Object
The PWG Semantic Model Work Group will host the review of the Document
Object Specification in their October 24th telecon. This review is in
preparation for the face to face review in New Orleans during the afternoon
of the Semantic Model day. I'm sending this note out to allow for adequate
time for people to review the document. Attached below is Tom Hasting's
information on the document and the teleconference information for the 24th.
A detailed agenda will be sent out early next week. I expect to discuss the
18 issues Tom has called out. Please send any comments you may have on the
document to the Semantic Model mail list (firstname.lastname@example.org)
To Subscribe to the Semantic Model Mail List: Send e-mail to
email@example.com, put SUBSCRIBE or SUBSCRIBE SM in the body (not subject).
Xerox Architecture Center
Voice: (585) 265-8755
FAX: (585) 265-8871
US Mail: Peter Zehler
800 Phillips Rd.
Webster NY, 14580-9701
This archive was generated by hypermail 2b29 : Thu Oct 17 2002 - 17:33:17 EDT